Troubleshooting - universalblue UBE2412-21 Manual De Instrucciones


If the display shows , the cooking zone is still hot.


If the residual heat indicator of a given cooking zone is lit, that
zone can be used, for example, to keep a dish warm or to melt
butter.

When the cooking zone cools down, the display goes off.
Incorrect or missing pot indicator

If you are using a pot that is not suitable, not correctly
positioned or not of the correct dimensions for your induction
hob, the message "No Pot" will appear in the display, If no pot is
detected within 120 seconds, the hob switches off.

6. TROUBLESHOOTING


Read and follow the instructions given in the section
"Instructions for use".

Check that the electricity supply has not been shut off.

Dry the hob thoroughly after cleaning it.

If, when the hob is switched on, alphanumeric codes appear on
the display, consult the following table for instructions.

If the hob cannot be switched off after using it, disconnect it
from the power supply.
Error Possible
code Cause
E0 No Pan or did not
detect the pan
E1 High voltage
E2 Low voltage
E3~E4 Abnormal
temperature.
Remedy
Put on the pan
Please inspect whether power supply is normal.
Power on after the power supply is normal.
Please inspect whether power supply is normal.
Power on after the power supply is normal.
Please inspect the pot.
Please restart after the hotplate cools down.
37