OPERATION FUNCIONAMIENTO
• Adjust the seat height of the walker to the lowest setting. Place your child in
the walker and check that both feet touch the floor. The child should have
only part of their weight on their feet when their legs are straight. Adjust the
walker height as needed as your child grows. Do not adjust height with child
in the walker. Discontinue using the walker if your child attempts to climb out,
reaches 30 pounds in weight or 32 inches in height, or when your child is
able to walk unassisted.
• Ajuste la altura del asiento del andador a su posición más baja. Coloque
al niño en el andador y verifique que ambos pies toquen el piso. El niño
debería tener solamente parte de su peso sobre los pies cuando las piernas
están derechas. Ajuste el andador según corresponda a medida que el
niño crece. No ajuste la altura si el niño está en el andador. Deje de usar el
andador si su niño intenta treparse para salir de él, si pesa 13,5 kg (30 lb) o
mide 80 cm o si puede caminar sin ayuda.
• The baby walker can be used for 3 different heights. To adjust height,
remove baby from walker. Turn the safety button lengthwise and press the
safety button until the mechanism is released. Adjust to desired height.
• El andador puede utilizarse en 3 alturas diferentes. Para ajustar la altura,
saque al bebé del andador. Gire el botón de seguridad a lo largo y
presiónelo hasta liberar el mecanismo. Ajuste a la altura deseada.
• When the position has been selected, check that the safety button turned
through 90 degrees to prevent the accidental release of the mechanism.
Always follow this procedure. Never use the baby walker if the button is not
in the sideways position. Important: Never change the height when the baby
is in the walker.
• Cuando haya seleccionado la posición, verifique que el botón de
seguridad esté girado 90 grados para evitar que el mecanismo se destrabe
accidentalmente. Siempre siga este procedimiento. Nunca use el andador si
el botón no está en la posición lateral. Importante: Nunca cambie la altura si
el bebé está en el andador.
19
19
19
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
OPERATION FUNCIONAMIENTO
FCC Statement
The FCC Statement applies only to electronic units
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interference
that may cause undesired operation.
WARNING:
Changes or modifications to this unit not
expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
20