BABYTREND WK14 F Serie Manual De Instrucciones página 5

Tabla de contenido

Publicidad

ASSEMBLY ASAMBLEA
TO ASSEMBLE WALKER
PARA ENSAMBLAR EL ANDADOR
1)
• To open the baby walker raise the
tray to the middle position (Fig. 1).
• Para abrir el andador, levante
la bandeja hasta la posición
intermedia (Fig. 1).
2)
• The baby walker can be used
for 3 different heights. Turn the
safety button and slide vertically
to adjust the height. See the
3 heights diagram under the
walker for indications of the
height being used (Fig. 2).
• El andador para bebés puede
utilizarse en tres alturas diferentes.
Gire el botón de seguridad y deslice
verticalmente para ajustar la altura.
Consulte el diagrama de 3 alturas
debajo de la andadora para ver las
indicaciones de la altura que se
esta usando (Fig. 2).
3)
• Check that the safety button is
turned 90 degrees to prevent
the accidental release of the
mechanism (Fig. 3).
• Verifique que el botón de seguridad
esté a 90 grados para evitar
que el mecanismo se suelte
accidentalmente (Fig. 3).
7
7
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
4)
Fig. 1
X
X
Fig. 2
Fig. 3
ASSEMBLY ASAMBLEA
• Attach the fabric nearest to the tray,
push the pin downward through the
fabric into to the hole of the frame until
it snaps into place. Repeat for the
opposite side (Fig. 4a).
• Insert the pins on the back of the seat,
into the holes by pushing downwards
through the fabric until each one clicks
(Fig. 4b).
• Lastly, insert the pins into the holes
behind the tray, by pushing downwards
through the fabric until each one clicks
(Fig. 4c).
NOTE: All pins should be aligned to the
corresponding holes of the frame and
click into place to ensure the fabric is
securely attached.
• Insert the Push Handle into the frame.
Push in firmly until it clicks into position.
NOTE: Do Not lift the walker from the
Push Handle (Fig. 4d).
• Coloque la tela más cercana a la
bandeja, empuje los pasadores hacia
abajo a través de la tela hasta los
orificios del marco hasta que encaje en
su lugar. Repita para el lado opuesto
(Fig. 4a).
• Inserte los pasadores en la parte
posterior del asiento, en los orificios
empujando hacia abajo a través de la
tela hasta que haga clic (Fig. 4b).
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Fig. 4a
Fig. 4b
Fig. 4c
8

Publicidad

Tabla de contenido
loading

Tabla de contenido