Infiniton CMPTRAL-TN96 Manual De Instrucciones página 17

Get the most out of your Infiniton cooker hood
English
Tips on how to get the most out of your new cooker hood
The operation of an Infiniton cooker hood is very simple thanks to the technology we have created to
make your day-to-day life easier. Follow these simple tips and enjoy your kitchen.
Turn it on a few minutes before you start cooking, a small gesture that helps to keep the air clean of
impurities. Do not turn it off just after cooking, leave it running for a few more minutes until it completes
its function of purifying the cooking vapours.
Protect the stainless steel surface easily
To preserve the original appearance of your new Infiniton stainless steel cooker hood, it is advisable to
treat it with a clean cloth impregnated with a specific product that prevents fingerprints and marks.
There are baby oils and professional products that treat stainless steel to prevent dust, lint and dirt in
general from sticking to it.
What is the recommended distance between the hob and the hood?
It will always depend on each model, although the minimum distance between the cooking zone and
the extraction zone is generally
extraction zone will generally be 55 cm for vitro-ceramic or induction hobs. If the hob is a gas hob, the
recommended distance will be slightly greater, 65 cm.
For built-in modules, this minimum distance should always be 50 cm for electric hobs and 65 cm for gas
hobs.
In extra-flat hood models, the distance may be reduced to 43 cm if a glass-ceramic or induction hob is
used.
Prevents odours
Our engineering team recommends using the extended run function, if the hood does not have this
function, you can leave it running for 5 to 10 minutes manually to absorb the rest of the vapours given off
during cooking.
Preventing odours while the hood is operating
When this happens, your filter is probably saturated and cannot absorb any more grease. If this ha-
ppens, the solution is simple: clean it and if it is in bad condition, you will have to replace it.
Grease filters should be cleaned once a month, either by hand or in your dishwasher. In the latter case,
try to do it at a low temperature. Place the filters of your cooker hood carefully on the grilles and not next
to other pieces of crockery. If you do it by hand, we recommend that you soak them in hot soapy water
for a couple of hours and then brush the filters, wash them again and leave them to drain.
How to clean the metallic filters of a cooker hood?
The filters can be cleaned by hand or in the dishwasher. Tips for washing by hand: soak the filters in hot
soapy water, clean them and rinse them thoroughly, then just drain them well.
then just drain them well. To do this in the dishwasher, be careful not to wash them together with the
crockery or cutlery if they are excessively greasy. Treat them beforehand with a concentrated degreaser
to removes the most stubborn grease.
2