Troubleshooting - Infiniton CMPTRAL-TN96 Manual De Instrucciones

Troubleshooting

Whenever there is a problem with the appliance, check if you can solve it by following the tables below.
If the problem persists, please contact customer support.
PROBLEM
Light on, but motor does not work
Light does not work, motor does
not work
Oil leakage
Lights not working
Insufficient suction
The Cooker hood inclines
Note: Any electrical repairs to this appliance must conform to your local, state and federal laws.Please
contact the service centre if in any doubt before undertaking any of the above.Always disconnect the
unit from the power source when opening the unit.
POSSIBLE CAUSE
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Power cord loose or
disconnected
One way valve and the outlet are
not tightly sealed
Leakage from the connection of
chimney and cover
Broken/Faulty globes
The distance between the cooker
hood and the gas top is too far
The fixing screw not tight enough
10
SOLUTION
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit cord to power outlet.
Switch power outlet on.
Take down the one way valve
and seal with sealant.
Take chimney down and seal.
Replace globes as per this
instruction.
Refit the cooker hood to the
correct distance.
Tighten the hanging screw and
make it horizontal.
English