fadini COMBI 787 Manual De Instrucciones página 12

COMBI 787
LOCKING THE OPERATING ARM
4
Fasten the operating arm by the ring and screw,
tightening very hard.
5 FITTING THE ARM CONNECTION PLATE
Fit the connection plate into the holes of the two arms.
Gate
manual
release
6
ADJUSTMENT OF THE OPENING AND CLOSING GATE STOPS (if case no ground fitting is allowed).
ATTENTION: THE MANUFACTURING COMPANY RECOMMENDS TO INSTALL OPENING AND CLOSING
! GATE STOPS PREFERABLY ON GROUND. IN CASES WHERE THESE CANNOT BE FITTED, IT IS POSSIBLE TO
MOUNT GATE STOPS INSIDE THE MOTOR FOUNDATION BOX AND ADJUST THEM AS DESCRIBED BELOW.
COMBI 787
ON THE LEFT GATE
Oil-hydraulic underground operator
for swinging gates
Plate connecting
the operating arms
Driving arm fitted onto
the Combi 787 shaft
Grease
Arm connected to the
gate release shoe
Adjustment screw
CLOSING gate stop:
close the gate, then
adjust the screw and
tighten the locking nut
Adjustment screw
OPENING gate stop:
open the gate to the
required open position,
then adjust the screw
and tighten the
locking nut
Operating arm
Combi 787 left
Details of the lever system Combi 787 left
ON THE RIGHT GATE
12
COMBI 787