Descargar Imprimir esta página

Helvex SQUADRA E-929 Guia De Instalacion página 2

Publicidad

Para placas barrene de acuerdo a las distancias que se muestran
2
en la figura. /
Drill the countertop according to the distances shown
in the figure.
* barreno Ø 3,4 cm max.
* hole Ø 1 3/8" max.
*3,8 cm
(1,5")
Placa para Lavabo
Bathroom Countertop
* Medidas Recomendadas
*Recommended Dimensions
Inserte la salida con el chapetón en el lavabo y verifique que se
4
coloque el empaque.
/ Place the faucet with escutcheon into the
sink hole and check that the gasket is placed.
Limpie la superficie.
Clean the surface.
Para purgar las líneas de alimentación, abra el suministro de
6
agua y cierre.
/ To purge supply lines, open and close angle
valves.
válvulas
angulares
angle valves
agua caliente
hot water
lavabo
sink
Espesor máximo de
placa de 3 cm. /
Maximum thickness
of 1,18" counter.
empaque
gasket
agua fría
cold water
Desenrosque los conectores y la tuerca, retire la rondana y el
3
separador.
/ Unscrew the connectors and the nut, remove the
washer and the separator.
rondana
washer
tuerca
nut
conectores
connectors
Inserte el separador y la rondana. Enrosque la tuerca para fijar y
5
enrosque los conectores.
Screw the nut to fix and screw the connectors.
separador
separator
tuerca
nut
Enrosque las mangueras (no incluidas) a los conectores y a las
7
líneas de alimentación.
/ Screw the hoses (not included) to the
connectors and the supply lines.
mangueras (no incluidas)
hoses (not included)
líneas de alimentación
(no incluidas)
supply lines
(not included)
separador
separator
/ Insert the separator and the washer.
rondana
washer
conectores
connectors
2

Publicidad

loading

Este manual también es adecuado para:

Squadra e929-1.9