Remote Control - Lasko AW300 Manual De Uso

OPERATION
(Figure 1)
1. Carefully remove the Heater from the bag and the carton.
2. Place the Heater on a firm, level surface. Plastic or rubber tabs,
like the feet on this unit, may stick to furniture surfaces and/
or hardwood floors. The unit may leave a residue that could
darken, stain or leave permanent blemishes on the finish of
certain furniture surfaces, including wood surfaces, and/or
hardwood floors.
3. Plug the cord set into a 120 volt outlet.
Be sure that the plug fits tightly into outlet.
When plugs fit loosely into receptacles, they may
slip partially or completely out of the receptacle
with only the slight movement of the attached cord.
Receptacles in this condition may overheat and pose
a serious fire hazard; if covered by a curtain or drape,
the fire hazard is even greater.
4. Press the Power Button ( ) to turn the Heater ON. The unit will
turn on in HI Heat mode by default. Press the Power Button
again to turn the Heater OFF.
5. The HI/LO Button (
) controls the current Heat Mode. Press
the button once for LO Heat Mode. Press the button again to
switch to HI Heat Mode.
6. Press the Oscillation Mode Button (
Press the Oscillation Mode Button again to stop Oscillation.
7. Timer Mode allows you to set the length of time the Heater will
run before turning itself off. Pressing the Timer Button (
increase the length of time from 1 to 8 hours, in 1 hour incre-
ments. Pressing the button again will turn off Timer Mode. After
a few seconds, the unit will display the current temperature, as
well as the Timer symbol.
8. The Automatic Thermostat Control allows the Unit to Shut off
once the room reaches the desired temperature. Press the
Thermostat Control Buttons (
the preferred room temperature. After a few seconds, the unit
will display the current temperature, as well as the Automatic
Thermostat symbol.
AUTO-DIMMING FEATURE
The illuminated controls will go into Auto-Dimming Mode 10 sec-
onds from the time the last button is pushed. The reduction in bright-
ness will keep the room darker during heater use. Once the controls
are touched, the display will return to the original brightness. The
Auto-Dimming Feature reduces the display brightness by 40%.

REMOTE CONTROL

All the functions performed with the Remote Control work identically
to the EZtouch™ Controls. Remove screw on battery cover before
you install the two "AAA" batteries (not included). Do not mix old
and new batteries. Do not mix alkaline, standard (carbon-zinc),
rechargeable (nickel-cadmium) or lithium ion batteries. Replace
screw on battery cover.
If you lose your remote control, please call Customer Service to
order a replacement at 1-800-233-0268, Monday through Friday,
between the hours of 8:00 a.m. and 5:00 p.m. EST.
EZclick™ FILTER SYSTEM
Press the EZclick™ Filter button to release the cover for the per-
manent filter. Clean the filter with a vacuum equipped with a brush
attachment every two weeks; this will help to maintain the optimum
filter performance. Remember to clean the filter before storing at
the end of the season.
NEW 6/18
MODEL AW300
) to begin Oscillation.
) to Increase or Decrease
(Figure 2)
(Figure 2)
) will
Figure 1
Figure 2
3
Power Button
HI/LO Button
Oscillation Button
Timer Button
Thermostat Buttons
Remote Control
EZclick™
Filter System
AW300ES