Troubleshooting After Installation - CAN SL Serie Manual De Instrucciones

OUTSIDE REMOVABLE GAS HOB UNITS ▪

TROUBLESHOOTING AFTER INSTALLATION

If the appliance does not work properly after installation, perform the controls in the table.
problem
There is a smell of gas near
the appliance
There is a smell of gas near
the outdoor gas valve or
connections
The gas flow
seems irregular
If the appliance still does not work properly after all the checks have been made, contact the
authorised local dealer.
ATTENTION!
Always disconnect the appliance from the power line or gas cylinder when not in use.
48
Make sure that the gas cocks are completely closed. If the problem has not been
solved, disconnect the appliance from the gas supply and ask for technical support.
Make sure that there are no gas leaks from the quick joint or fitting (by using only a
water and soap solution) and that the flexible hose is not damaged (cut, abraded,
punctured, etc.). If the problem has not been identified and solved, disconnect the
appliance from the gas supply and ask for technical support.
Check that the gas cock is completely open.
Check that the fuel supply circuit has a suitable flow rate.
Check that the burner spreaders and relative caps are positioned correctly and free
from obstructions.
Check that the nozzles are suitable for the type of gas used.
Check compatibility and correct calibration of the pressure regulator, if applicable.
Check that the gas supply hose is not choked/obstructed and that the shut-off valve
on the gas valve is fully open.
SL series
potential solutions