Cold Water Connection - CAN SL Serie Manual De Instrucciones

COLD WATER CONNECTION

ATTENTION!
Always check the supply conditions of the on-board system or of any other water network
before making any connections (maximum operating pressure not exceeding 4 bar).
Before connecting the cold water, check that:
▪
the cold water supply line is free from obstructions and has a sufficient flow rate to guarantee the
appliance proper operation;
▪
there is a universal quick-joint water outlet in close proximity to the appliance;
▪
A flexible cold water hose is available, long enough to allow connecting the appliance to the on-board
system by means of suitable connection fittings at both ends, one of which must have a universal
female-type quick joint (for gardening products/leisure time);
▪
A valve suitable for disconnecting the on-board system (Please note: this valve must always be
closed during installation and maintenance of the appliance).
The appliance is equipped with a universal quick joint terminal for cold water, located on the external frame
of the appliance, near the gas hose connection point. Always check the supply conditions of the on-board
system or of any other water network before making any connections (maximum operating pressure not
exceeding 4 bar).
ATTENTION!
Always disconnect the appliance from the water supply after each use and before storing it
in its recess.
ATTENTION!
To install the appliance, follow the instructions in this manual. Non-compliant installation can
lead to inconveniences, failures, damage and serious hazards for the installer and the user.
VERSION LC VERSION LL
49