Connecting The Water Supply Line - Glacier bay TBD N2420E-SF Manual Del Usuario

Installation (continued)
6

Connecting the water supply line

□
Connect the water supply line (not included) between the
tank (A) and shut-off valve.
□
Tighten the tank connection coupling nut ¼ turn beyond
hand tight.
□
Turn on the supply valve and allow the tank (A) to fill.
□
Check for leakage at all connections and tighten or correct
as needed.
NOTE: Do not overtighten the tank connection.
7
Installing the seat with lid
□
Turn the toilet seat with lid (C) upside-down.
□
Insert the toilet seat hinge gasket (KK) onto the bottom
of the hinge. Firmly press the (4) raised bumpers into the
associated openings on the hinge.
□
Insert the lock bolt (GG) in the bolt trough (1), then adjust
the lock bolt (GG) to make the hole distance match with the
toilet.
□
Turn the toilet seat with lid (C) over so that the lock bolts
(GG) protrude downward.
□
Insert the lock bolts (GG) into the holes on the toilet (B) and
adjust the toilet seat and lid (C) to find the best assembly
position.
□
Place the washer (HH) and the lock nut (II) onto the lock
bolt (GG) from underneath the toilet (B) and tighten the lock
nut (II) firmly to secure the seat and lid (C) in place on the
toilet (B). Close the bolt trough covers and snap into place.
GG
HH
II
7
KK