Mount Bracket - Ford Pro Guia De Instalacion

Mount Bracket

MOUNT BRACKET TO WALL
A Locate Stud with Stud Finder
B Verify Gang Box is installed on right side of stud.
Top Bracket hole should be between 35-60" from floor.
See page 2 dimensional graphic.
No Gang Box needed if AC Conduit Installation
C Line up Mounting Bracket opening with Gang Box as
shown, use Level to align Bracket and mark the two
center mounting holes.
Use Drill with 7/32" bit to drill pilot into stud.
D
Align Bracket on wall and Install (2) 3/8" x 2-1/2" Hex
E
Lag Bolts into wall using 9/16" Socket to tighten to wall.
(See Figure below).
7/32" Pilot holes in the stud wall
Install Lag Bolts using
9/16" Hex Head
QTY KIT ITEM
1
2
TOOLS NEEDED
STUD FINDER
LEVEL
Drill with 7/32" Pilot Bit
9/16" SOCKET
Align Gangbox with opening
in Mounting Bracket
P a g e
MOUNTING BRACKET
3/8" X 2-1/2" HEX LAG BOLT
Gang Box right side stud
mount (Standard Method)
| 8