Technical Specifications - Velleman GASIRON2 Manual Del Usuario

6. Use
Soldering iron:
on/off switch to the ON position to let the gas flow.
soldering head forward until you can see the nozzle through the
ignition vent. Then, light the gas by bringing an open flame to the
ignition vent.
disappear inside the head and will generate heat there.
on-off switch to OFF to extinguish the soldering iron.
G
to ON to let the gas flow and bring an open flame next to the
nozzle.
iron.
Hot blower:
turning it counterclockwise. Ignition and extinguishing are the
same as for the soldering iron.
Flame/heat adjustment:
gas volume control. Rotate it to the + or the - to increase or
decrease the gas flow.
Refilling the gas tank:
OFF and the GASIRON2 has cooled down completely.
device in a well-ventilated area away from any ignition source and
away from other people. Do not smoke while refilling the gas torch.
●
insert the nozzle of the butane canister into the gas refill valve and
press the canister down to let the gas flow from the canister into
the gas tank of the soldering iron.
pull the canister out of the refill valve.

7. Technical Specifications

autonomy .............................................. 40 min. (average use)
temperature ............................................................. ≤ 450 °C
spare bit ......................................................... GASIRON2/SPB
V. 03 – 29/11/2022
●
●
Release the soldering head. The flame will
as torch ●
: Remove the soldering head.
●
Set the on-off switch to OFF to extinguish the soldering
●
Screw the soldering tip off the soldering head by
Refill with butane gas only.
GASIRON2
Make sure the exhaust vent faces up.
●
Adjust the gas flow by means of the
●
Make sure the on-off switch is set to
●
Hold the GASIRON2 upside down,
●
5
●
Set the on-off switch
When the gas stops flowing,
©Velleman Group nv
●
Set the
●
Pull the
●
Set the
●
Refill the