Publicidad
Idiomas disponibles
Idiomas disponibles
Securing Children - Harness Operation
WARNING
Avoid Serious injury To children From Falling or Sliding out:
• ALWAYS use harness provided to safely hold child into seat.
• Snugly adjust harness around each child.
• NEVER leave children unattended, even when sleeping.
• Always keep children in view.
• DO NOT allow children to climb onto buggy or stand in seat.
1. Shoulder harness should be adjusted
prior to child being placed in seat. The
lowest position (1) is for a small child. The
middle position (2) is for a medium size
child. The top position (3) is for a large size
child up to 50 lbs. The shoulder belts should
be as even with the shoulders as possible.
See Figure 4
To reposition to a different height, Pull out
the Harness Strap Anchor (I) from the back
of the seat. Rotate the Anchor 90 degrees
and push through the seat from the back to
front.
Select the correct opening and reverse the
procedure. Pull on the strap to make sure
the anchor is seated securly.
See Figure 5 and 6
Note: Make sure both anchors are placed
into a slot at the same hieght.
Step 1
3
2
1
Figure 4
I
Figure 5
6
1. Secure child with harness straps by
positioning harness strap (M) between
legs and placing shoulder harness strap
(J) over shoulders and waist strap (K) over
childs thighs. Snap buckle tabs (O)
together into top of harness buckle (L).
2. To secure the child into the seat and
tighten the entire harness, pull up on the
strap (M) on the bottom of the seat.
AB20008A_G2
3. To adjust the harness for looser fit,
press the lever on the harness strap
adjuster (N) and release strap to desired
position
See Figure 7 and 8
AB20008A_G11
Step 1 Continued
I
Figure 6
Step 2
J
K
Figure 7
J
O
L
M
Figure 8
7
AB20008A_12
L
M
N
AB20008A_G13
J
O
AB20008A_G14
Publicidad
