Introduction; Requirements; Connections And Light-Up Indicators (Led) - Fermax DUOX PLUS Manual De Instrucciones

1. INTRODUCTION

The Duox Plus IP Camera Interface allows IP CCTV cameras to be integrated into a Duox
Plus installation.
The module is able to connect to the video stream sent by the IP cameras in H264 format
(within certain parameters), process it and convert it into a DUOX PLUS signal that is
connected directly to the Duox Plus bus.

2. REQUIREMENTS

This Interface will handle requests from those monitors (APP BLUE) that request auto
switch-on via the bus or via the Blue App. The Interface behaves like an outdoor panel both
in terms of topology (installation and adaptation) and when configuring the type of panel
(General Entrance or Interior Block, indicating the block number). It is important to point out
that no two devices configured in the same installation can be the same (Example: If there
is an outdoor panel configured as block 0 panel 0, it will not be possible to have an Interface
with this configuration).
-If the interface is configured as General Entrance it shall only allow the management
of one camera.
If the interface is configured as a Block, it will allow the management of up to two cameras.
- Each camera shall be powered externally with its own power supply or through a POE switch.
- The camera must be configured beforehand with its IP, user and password.
- The Interface shall be powered directly from the Duox Plus bus.
3. CONNECTIONS AND LIGHT-UP INDICATORS (LEDS)
3
SW1
C
OFF
1) SCAN QR
2) fermaxinterface.com
R5
4
DUOX PLUS IP CAMERA INTERFACE
1
B B
MADE IN SPAIN
INTERFAZ CAMARA IP/DUOX PLUS
IP/DUOX PLUS CAMERA INTERFACE
BUS
REF. 9454
4
PRG
5
PWR
WIFI
US Patent No. 9.215.410
9.762.852
FERMAX ELECTRONICA, SAU
AV TRES CRUCES, 133
46017 VALENCIA - SPAIN
2
BB: Connection of the DUOX Plus bus.
1
RJ-45: Ethernet/IP camera connection
2
SW1: Line adapter included.
3
Right: Without OFF line adaptation. (by
default)
Left: Type C adaptation.
PRG: Programming pushbutton.
4
Pressing for 2 seconds activates the web
server. After 5 minutes of inactivity, it is
deactivated.
PWR LED: Standby blinking 1 sec (on/off)
5
WIFI LED: Continuous when there is a
device connected to the WiFi it generates.
Switches off when the web server is
deactivated.