Technical Data; Safety Notes; Presentation - LEGRAND LEXIC Rex2000 D21F Modo De Empleo

Radio controlled time switch
Rex2000 D21F
037 28, 037 29
NT 29 07 34 01

Safety notes

• Installation of these products should only be undertaken by a qualified electrician.
• The operational and electrical safety is only guaranteed if the product is installed using its proper accessories, in a position as specified in
the installation instructions (distribution panel).
• Any interference with the product makes the guarantee void.
• If the time switch is mounted near equipment where heat produced raises the local ambient above 55°C. Then a space should be put
between the time switch and the equipment (e.g.
Function
The Rex2000 D21F is a digital 7 day time switch with a circular segmented display for general rail mounting use. By means an outside attached antenna, reference 047 50 (not extend of delivery by
reference 037 29), it is possible to receive the time code. Up to 8 program pictures can be set. A program picture incorporates both ON and OFF time. If no button is pressed for 60 seconds during
programming the time switch goes back to the start position. The copying function enables program to be copied to other days. Minimum switching time is 1 minute. The switching times are protected
but can be overlaid by other programs. Programs are displayed with a minimum segment size of 30 minutes. The time and the week days are presented digitally.

Presentation

Real time, switching time
Clr = delete switching times
Copy = copy switching times
Actual day of the week
or program day
Segment display of the
existing program
1 segment = 30 minutes
Receipt of time code
Button Menu
activates the menu or
breaks off the process
All manuals and user guides at all-guides.com

Technical data

Supply voltage:
Consumption:
Contact rating:
Parallel compensation:
Accuracy:
Terminal capacity:
Program pictures:
Battery reserve:
Storage ambient:
Working ambient:
Line length of antenna:
1 ⁄ space module code 044 40 or 1 space module code 044 41).
2
Menu
SET TIME CHECK... ON
PROG NEW...OFF
Symbol for automatic operation
24
Symbol for manual override
18
6
Symbol for continuous override ON
1234567
Symbol for continuous override OFF
12
State of contact
ON
OFF
MENU OK
Button OK
confirms the input
Button moves the flash
Button minus and plus
changes the values
037 28, 037 29
230V 50/60Hz 120V 50/60Hz 24V AC/DC
ca. 1,6W
changeover contact 16A 250V~µ cos ϕ = 1
60VA max. 7µF
radio controlled
single strand multi strand
2
1,5 to 4 mm 1,5 to 2,5 mm
56
10 Minutes
-20°C to +60°C
-20°C to +55°C
max 30 m
L
N
1200W 1200W 2300W
2
2300W 1800W
Connection
250V~
+
GB
Operating instructions
®
1800W 1800W
Antenna reference 047 50