LEGRAND WattStopper RD-200 Instrucciones De Instalación

Please read all instructions before installing
Dimming Wall Switch
with Manual ON/OFF/Dim
Lens
Air Gap Isolation Switch
Lighted Switch
ON/OFF/DIM button
SPECIFICATIONS
Voltage ............................................................... 120VAC, 60Hz
Load (Single Pole Circuit) .......................................25-500 Watt
Compatibility ...................................................Incandescent
Time Delay Adjustment ....................15 seconds to 30 minutes
Light Level Adjustment ....................................... 10 fc to 150 fc
Environment ..................................Residential Indoor use only
Operating Temperature ............... 32° to 131°F (0° to 55°C)
Humidity ...................................... 95% RH, non-condensing
Electrical Supply Wire Requirement
Minimum temperature rating ..........................75°C (167°F)
Tools Needed ......................................... Insulated Screwdriver
DESCRIPTION AND OPERATION
The RD-200 Dimming Wall Switch Vacancy Sensor is designed to replace a
standard light switch or dimmer. It is ideal for living and dining rooms, family
rooms, bedrooms, bathrooms or any other indoor area in a residential space
where occupancy sensor-based manual ON/OFF and dimming control is
desirable.
Like a standard switch, you press the ON/OFF/DIM button to turn the dimmable
light (load) ON and OFF. Unlike a standard switch, the RD-200 automatically turns
OFF the controlled load after the coverage area has been vacant for a period of
time (Time Delay). If motion is detected within 30 seconds after it automatically
turns OFF, the RD-200 automatically turns the load back ON. Like a standard
dimmer, once the lighting load is ON, you can dim it UP or DOWN by pushing and
holding the ON/OFF/DIM button. When you push the ON/OFF/DIM button to turn
the dimmable load ON, the RD-200 recalls the last used dimming level.
While the sensor is factory preset as a Vacancy Sensor with manual ON operation,
it can be adjusted to work as an Occupancy Sensor that turns the controlled load
ON to the last used lighting level automatically upon detecting occupancy in the
area.
Lighted Switch
To help you locate the RD-200 in a dark room, the amber LED illuminates the
ON/OFF/DIM button while the controlled load is OFF. When the controlled load is
ON, the LED is OFF.
The lighted switch ON/OFF/DIM button can be used to manually turn ON and OFF
the lighting load and to dim it UP and DOWN.
To turn the load ON, tap fi rmly on the ON/OFF/DIM button once. The amber LED
turns OFF and the load turns ON to the last used dimming level. The lighting load
may or may not appear to be ON depending on how low the lights were set the
last time they were dimmed.
Once the load has been turned ON, push and hold the ON/OFF/DIM button to
dim the lights UP or DOWN. The RD-200 will cycle the lights UP and DOWN
continuously until the ON/OFF/DIM button is released. To reverse the dimming
direction before a full cycle is completed, momentarily release the ON/OFF/DIM
button, then push and hold it again. This feature will allow you to reach the
desired dimming level quicker.
Call 888.817.0571 for Technical Support
RD-200
Vacancy Sensor
Wire Strippers
Santa Clara, CA 95050