General Power Tool Safety Warnings; Rotary Hammer Safety Warnings - Makita M8700 Manual De Instrucciones

ENGLISH
(Original instructions)
1 Switch trigger
2 Lock button
3 Reversing switch lever
4 Action mode changing knob
5 Rotation only
6 Rotation with hammering
SPECIFICATIONS
Capacities
No load speed (min
Blows per minute
Overall length
Safety class
• Due to our continuing program of research and
development, the specifications herein are subject to
change without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s).
The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.

General power tool safety warnings

WARNING: Read all safety warnings, instruc-
tions, illustrations and specifications provided with
this power tool. Failure to follow all instructions listed
below may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
7 Thumb screw
8 Protrusions
9 Grooves
10 Bit shank
11 Bit grease
12 Bit
Model
Concrete
Core bit
Diamond core bit (dry type)
Steel
Wood
–1
)
Net weight

ROTARY HAMMER SAFETY WARNINGS

Safety instructions for all operations
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
ENE042-1
3. Hold the power tool by insulated gripping
surfaces, when performing an operation where
the cutting accessory may contact hidden wiring
or its own cord. Cutting accessory contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
ENF002-2
Safety instructions when using long drill bits with
rotary hammers
1. Always start drilling at low speed and with the bit
tip in contact with the workpiece. At higher
speeds, the bit is likely to bend if allowed to rotate
freely without contacting the workpiece, resulting in
personal injury.
GEA010-2
2. Apply pressure only in direct line with the bit
and do not apply excessive pressure. Bits can
bend, causing breakage or loss of control, resulting
in personal injury.
Additional safety warnings
1. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
2. Be sure the bit is secured in place before
operation.
13 Chuck cover
14 Depth gauge
15 Chuck adapter
16 Keyless drill chuck
M8700
22 mm
54 mm
65 mm
13 mm
32 mm
0 – 1,100
0 – 4,350
362 mm
2.5 – 2.9 kg
/II
GEB243-1