General Power Tool Safety Warnings; Rotary Hammer Safety Warnings - Makita HR4501C Manual De Instrucciones

ENGLISH (Original instructions)
1. Switch trigger
2. Switch lever
3. Adjusting dial
4. Change lever
5. Pointer
6. Lock button
SPECIFICATIONS
Capacities
No load speed (min
Blows per minute
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to EPTA-
Procedure 01/2014, are shown in the table.
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
ROTARY HAMMER SAFETY
WARNINGS
Safety instructions for all operations
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
Explanation of general view
7. Power-ON indicator lamp (green)
8. Service indicator lamp (red)
9. Side handle
10. Clamp nut
11. Side grip
12. Bit shank
Model
Carbide-tipped bit
Core bit
-1
)
Net weight
Safety class
HR4501C
8.2 - 8.4 kg
2. Use auxiliary handle(s), if supplied with the tool.
ENE044-1
Loss of control can cause personal injury.
3. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
ENF002-2
cutting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Safety instructions when using long drill bits with
rotary hammers
1. Always start drilling at low speed and with the bit
tip in contact with the workpiece. At higher speeds,
the bit is likely to bend if allowed to rotate freely
GEA010-2
without contacting the workpiece, resulting in personal
injury.
2. Apply pressure only in direct line with the bit and
do not apply excessive pressure. Bits can bend,
causing breakage or loss of control, resulting in
personal injury.
Additional safety warnings
1. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
2. Be sure the bit is secured in place before
operation.
3. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
GEB243-1
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
4. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
13. Bit grease
14. Bit
15. Chuck cover
16. Depth gauge
17. Clamp screw
18. Blow-out bulb
HR4510C
45 mm
125 mm
130 - 280
1,250 – 2,750
458 mm
8.9 - 9.0 kg
/II
HR4511C
9.0 - 9.1 kg
5