Assembly - Daewoo DALCS18-1 Manual Del Usuario

ENGLISH

6. ASSEMBLY

WARNING! Remove the battery pack before assembly. Do not use grinding discs.
Wear protective gloves, the cutting edges of the saw blade teeth are sharp. The cutting
edges present a s risk of injury.
Never adjust cutting depth and angle while the blade is turning.
6.1 Attaching the saw blade (Fig. D)
a) Press and hold the spindle lock button (9) and use allen
key to remove blade bolt and outer blade flange.
b) Retract the lower blade guard (3) by raising the blade
guard lever.
c) Slip the blade in position. Ensure arrow on the blade
points in the same direction as the arrow on the upper
blade guard.
d) lnsert the outer flange and blade clamp bolt.
e) Press down the spindle lock button (9) and tighten the
blade clamp bolt with allen key.
6.2 Removing the saw blade (Fig. E)
a) Use the allen key to loasen the blade clamp bolt while
pressing down the spindle lock button.
b) Remove the blade clamp bolt and outer flange.
c) Raise the lower guard (3) and remove the saw blade.
6.3 Adjusting the cutting depth (Fig. F)
a) Loasen the cutting depth adjustment knob (18) by
turning it anti-clockwise. The max. cutting depth is 54mm
(90º) and 40mm (45º).
b) Hold the base piate against the edge of the workpiece
and lift thesaw to the desired cutting depth.
c) Tighten the cutting depth adjustment knob.
6.4 Setting the mitre angle (Fig.G}
a) Loasen the mitre angle adjustment knob {12) by turning
it anti-clockwise.
b) Adjust the mitre angle of your cut.
e) Tighten the mitre angle adjustment knob.
6.5 Mounting the guide bar (Fig.G}
a) Loasen the guide bar knob {10) by turning it anti-cloc-
kwise..
b) Slide the guide bar through the slots in the base plate to
the desired width.
e) Tighten the guide bar knob.
FIG D
FIG E
FIG F
FIG G
8