Size And Position Controls; Geometry Controls - NEC MultiSync FP1355 Manual Del Usuario

All manuals and user guides at all-guides.com
Degauss: Eliminates the build-up of stray magnetic fields which alter the
correct scan of the electron beams and affect the purity of the screen
colours, focus, and convergence. When activated, your screen image will
jump and waver a bit as the screen is demagnetised.
Caution: Please allow a minimum of 20 minutes to elapse between
uses of the Degauss function.

Size and Position Controls

AutoAdjust: Automatically adjust the horizontal and vertical size and
position settings for applicable timings.
Left/Right: Moves the image horizontally (left or right).
Down/Up: Moves the image vertically (up or down).
Narrow/Wide: Decreases or increases the horizontal size of the image.
Short/Tall: Decreases or increases the vertical size of the image.
Colour Control/Colour Control System
Colour presets 1 through 5 selects the desired colour setting. The bar is
replaced by the colour setting choice from 1 to 5. Each colour setting is
adjusted at the factory to the stated Kelvin. If a setting is adjusted, the
name of the setting will change from Kelvin to Custom.
Red, Green, Blue: Colour Control System decreases or increases the
monitor's red, green or blue colour guns depending upon which is
selected. The change in colour will appear on screen and the direction
(decrease or increase) will be shown by the bars.
sRGB Mode: sRGB mode provides the suitable colour managed picture
image. You can not change Red, Green and Blue colours individually.
NOTE: In this mode, Brightness and Contrast are not adjustable.

Geometry Controls

Geometry Controls Menu
The Geometry controls allow you to adjust the curvature or angle of the
sides of your display.
Sides In/Out (pincushion): Decreases or increases the curvature of the
sides either inward or outward.
01b_english
English-5
5 22.02.2001, 14:12 Uhr