Mx Onda MX-PG2203N Manual De Usuario E Instalacion página 20

• This appliance is designed for domestic, non-professional use
only. MX ONDA will not accept any responsibility and the
guarantee will be invalid in case of improper use or non-
compliance with the instructions.
• Gas supply connection:
- The gas supply connection must be carried out by an
authorized installer in accordance with current standards.
- Check that the hob is adapted to the type of gas used.
- Verify that the gas supply pressure is within the values
specified in the corresponding section of the manual.
- To avoid damage to the interior of the hob, connect the gas
outlet in such a way that it is not forced.
- If you need to use the 90º elbow or the adapter for the
flexible tube, do not forget to place the insulation joints, as
well as the subsequent verification of the absence of gas
leaks.
• The surface, supports, and burners become hot during use, so
extreme care should be taken during use, as well as after use.
Wait until the surfaces are completely cool.
• Make sure that the outlet where the hob is connected is easily
accessible (but not by children). To disconnect the hob from
the electrical network, gently pull the plug from the socket.
Never do it by pulling on the cable.
• After prolonged use, additional ventilation may be required, eg
open a window or increase the speed of the range hood.
• In case of failure, anomalies, if the hob, burners or supports
have fallen and deteriorated, do not use the appliance and do
not try to repair it yourself. Contact the nearest MX ONDA
Official Technical Service.
4