Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENT THE GAS VALVES
If the pressure in the gas supply (natural gas or butane gas) differs from that
specified for the gas hob, it may happen that the flame is irregular or that it
goes out when the control is at minimum, in which case it would be necessary
to adjust adjusting the valve, to do this follow the following process:
1.
Turn on the cooking zone you want to adjust, turn the knob to the maximum flame
level position (
completely hot.
2.
Turn the knob counterclockwise to the (
3.
The flame should not go out or move towards the burner, if it goes out or moves
towards the burner it will be necessary to readjust the valve.
4.
To access the valve reset screw, remove the button corresponding to the cooking
zone you want to adjust by pulling it up (Figure 4).
5.
Using a flathead screwdriver readjust the screw next to the central axis of the valve
(Figure 5).
6.
For butane gas turn the screw clockwise and for natural gas turn the screw
counterclockwise. In the minimum flame position (
be between 6 and 7 mm.
7.
Repeat steps 1 through 5 with the other cooking zones.
) and wait approximately 10 minutes for the safety sensor to be
Figure 4
) minimum flame level position.
), the height of the flame must
15
Figure 5
Publicidad
Tabla de contenido
