Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installation of feet
Take out the whole machine, and put it on the flat table in order to avoid machine scratching, then
take the feet out of the plastic bag and connector ( as shown in the picture)
DIRECTION FOR USING
1. Turn the heater on by pressing the ON/OFF button on the rear of heater.
Pressing button on the control panel or by pressing the Power button on the supplied remote
control.
Once power is off, heating element will stop working
Power for heat-HIGH mode is 2000W; heat-LOW is 1000W, and turn off the heat.
2.
Adjust the brightness of the flame and turn off
3.
4. Pressing buttom for timing ( 0.5h/1.0h/2.0h/3.0h/4.0h/5.0h/6.0h/7.0h/8.0h)
-17-
Publicidad
Tabla de contenido
