Investigation of Common Problems
PROMPT TONE
Lifting Condition
The robot is not yet ready
Low battery
Low battery
Battery is too low,
will shut down soon
Charging problem
Main brush get tangle, please
clean main brush
Right wheel jammed, please
clean right wheel
Side brush jammed, please
clean side brush
Bumper sensors has been blocked
Cli detect sensor has been blocked
Vacuum Motor jammed,
please clean it
The robot get stuck,
please remove the robot
The robot jammed,
please remove the robot
Border sensor has been blocked
The laser head is stuck
The laser head obscured
CAUSE OF FAILURE
Robot suspended
Press button
when ground or collision
detection is e ective
Low Battery Reminder when robot
in no charge base area
Low Battery Reminder when robot
in no charge base area
Low Battery Reminder when robot
in no charge base area
Charging station problem
Roller Brush get tangle
Wheel Jammed
Side brush jammed
Bumper problem
Ground sensor problem
Vacuum motor jammed
The robot is stuck or the laser
head is stuck
The robot jammed or the laser
head is obscured
Right border sensor is obscured
The laser head is stuck
The laser head is obscured
SOLUTION
Please put the robot back to the ground
and press the start button again
Please check whether the font bumper can
be bounced normally,
and the sensors cleaned
Please charge the robot manually
Please charge the robot manually
Please charge the robot manually
Please check whether the connection
between robot and charging pole pieces
connected well, or use
adaptor to charge directly
Please check whether the roller brush is
twinned and clean up
Please check whether the wheel is
entangled and clean up
Please check whether the side brushes is
twinned and clean up
Please check whether the font
bumper can be bounced normally
Please check whether the cli sensor get
dirtied or be obscured
Please check whether the dust bin enter is
blocked
Please check whether the robot is
stuck or the laser head is stuck
Please check whether the robot
jammed or the laser head is obscured
Please check the sensor is obscured
Please check the robot is stuck
Please check the laser head is obscured