Vibration Information; Assembly And Operation - Worx Nitro LEAFJET WG585E Manual Original

VIBRATION INFORMATION

Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be used
in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
12
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
SUGGESTED BATTERIES AND
CHARGERS
Category
20V Battery
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose the
type according to the work you intend to undertake.
Refer to the accessory packaging for further details.
Store personnel can assist you and offer advice.
40V Cordless Blower
a < 2.5 m/s
h
K = 1.5 m/s²
Type Capacity
WA3014 4.0 Ah
WA3883 4.0 A
OPERATION
INTENDED USE
The blower is intended for residential use only. Use the
2
blower outdoors to move yard debris as needed.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Charging the battery pack
NOTE:
• The batteries are shipped uncharged.
Each battery must be fully charged
before the first use.
• Always fully charge the two batteries at
same time. More details can be found in
charger's manual.
WARNING! The charger and battery
pack are specially designed to work
together, so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard
will occur.
Checking the battery condition
NOTE: Fig. A2 only applies for the battery
pack with battery indicator light.
Installing & removing the battery pack
NOTE:
• This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the two
batteries at the same time.
• When you use two batteries with
different power,the machine will only
run to the level of the lowest charged
battery.
Battery indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged,
even though the machine may still be
capable to work. Continuing to operate
your machine with the battery in this
discharged condition may reduce the life
and performance of your battery.
When no light is illuminated, at least one
battery is not fully installed or battery
may be defective, please double check the
batteries are fully seated into position.
ASSEMBLY
FIGURE
See Fig. A1
See Fig.
A2
See Fig.
B, C
See Fig. D
EN