Emerio DWC-127633 Manual De Instrucciones página 10

CLEANING AND MAINTANANCE
Note: Clean the appliance once or twice a week (depending on usage).
1. Clean the surface
Use a soft cloth moistened with mild soap, and then use a dry cloth to wipe it again.
2. Clean the filter and heating plate
1) Open the door and take out the basket. Rotate anticlockwise to disassemble the filter set, which have
3 parts, filter mesh (A), main filter (B) and fine filter (C).
2) Use water to flush and brush each part of the filter set.
3) Use a damp cloth to clean the heating plate which is under the filter mesh (A) (if there is any limescale).
4) After cleaning, replace the filter set.
5) Clean the filter once or twice a week (depending on usage).
3. Clean the spray arm
1) Open the door, take out the basket, then pull out the spray arm upwards.
2) Use water to flush and brush the spray arm.
3) After cleaning, press the spray arm back into position, make sure the spray arm can move smoothly.
4) Clean the filter one or twice a week (depending on usage).
FAULT & PROBLEM
Fault codes
Code Fault
E2 Draining
E3 Overflowing
E4 Temperature fault
E5 Communication fault
E6 Heating plate fault
E7 Hydraulic pressure fault
Problems
Fault
Tableware is not
clean
Appliance does not
start
Cannot select the
program
How to deal with
1. Check drain pipe, be sure the pipe is straight, no bending;
2. Power off to check if anything blocks the filter or drain pipe;
3. Be sure all pipes are not blocked by something.
Tilt the machine to 30-45 degree, let water flow out.
Restart the appliance, if still fault, please contact our service
department.
Reason
Incorrect tableware loading
Spray arm trapped
Blocked spray arm
Blocked filter
Incorrect filter installation
Incorrect program selection
No detergent
Water shortage
The door is not closed fully
The appliance is working.
How to deal with
Be sure enough gap between the tableware.
Be sure noting trap the spray arm.
Clean the spray arm.
Clean the filter set.
Correctly assemble the filter set.
Select appropriate washing program.
Add detergent (block/powder/liquid).
Add water till the indicator light illuminates white
Check the door and close the door fully.
Touch " " for 3 seconds to quit the program-
in-progress or wait for the program finishing.
- 9 -