Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3 – Adjust the Scanner Floor Extender
•
Adjust the floor extender to accommodate
the longest document
Slide Floor Extender
Step 4 – Scanner Start-up and Shut-down
Power ON the scanner by pushing and holding down the Power
•
Button for 2 seconds.
•
When the power light starts blinking, the scanner is ready is ready
for application use.
•
The power light will stop blinking and will be on during document
scanning.
•
To turn OFF the scanner, push and hold the Power Button until the
Power Button light turns OFF.
Power
Button
8227 5691-000 August 2016
8227 5691-000 August 2016
8227 5691-001 November 2016
8227 6462-000 August 2022
8227 5691-001 November 2016
SmartSource Micro/Micro Expert Elite W/ Inkjet – Setup and Operation
Power Button Light
LED
LED
COLOR
STATE:
STATUS:
SOLID USB or Ethernet
RED
cable not connected
RED
BLINKING ERROR
BLUE
BLINKING Cable is connected
BLUE
SOLID Actively Scanning
BLINKING
Unit requires
PURPLE
or SOLID
cleaning
Step 5 – Preparing Documents for Processing
To improve document throughput and scanning, it is recommended
that the operator perform the following document preparation steps
prior to loading documents into the scanner:
•
Remove all staples, paper clips and rubber bands
•
Straighten any bent corners, folds, creases or curls
Step 6 – Inserting Documents into the Scanner
•
Place document into the feeder bay, aligning the bottom edge of
the document with the feeder bay floor
•
Align the leading edge of the documents with the check graphic
located on the top cover (as shown)
•
Align the bottom of ID cards with the feeder bay floor (as shown)
Front Entry – Check Insertion
Front Entry- ID Card Insertion
2 of 4
Publicidad
