Lawn Mower - Husqvarna LC 247i Manual De Usuario

Lawn mower

The warning indicator (error LED) is found below
the battery lid ((LC 247i)) or on the control panel
((LC 347iVX, LC 353iVX)).
Problem Error LED (number
of flashes)
Error LED flash- 3
es. The product
does not operate
correctly.
5
6
10
Error LED flashes. 0
The product stops.
3
8
9
12
Other errors. If other errors occur, turn the safety key to 0, remove the battery and speak to an approved
service agent.
1
LC 347iVX, LC353iVX
20
Cause
The blade is blocked.
The motor speed drops too
much, and the motor stops.
1
The wheels or transmission is
blocked.
The motor control is too hot.
Battery connector failure.
There is overload in the mo-
tor.
The battery is weak.
Battery error or no signal from
battery.
Incorrect start procedure. The
motor brake handle has been
engaged before the motor
starts.
Solution
Turn the safety key to 0 to prevent ac-
cidental start. Remove the battery and
wait a minimum of 5 seconds. Remove
possible obstacles and make sure that
the blade can rotate freely. If the prob-
lem continues, speak to an approved
service agent.
Increase the cutting height. Refer to
set the cutting height on page 15 .
Turn the safety key to 0 to prevent ac-
cidental start. Remove the battery and
wait a minimum of 5 seconds. Remove
the possible obstacles and make sure
that the wheels can rotate freely. If
the problem continues, speak to an ap-
proved service agent.
Stop the motor and wait until it has be-
come cool.
Examine the battery connector.
Increase the cutting height. Refer to
set the cutting height on page 15 .
Charge the battery. Refer to
the battery on page 15 .
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes. Refer
Battery on page 19 .
to
Release the motor brake handle and
wait approximately 5 seconds. Push the
motor brake handle down again to start
the product.
1696 - 004 - 14.11.2022
To
To
To charge