Technical Data; Eu Declaration Of Conformity - Atlas Copco 4211603085 Información Sobre Seguridad, Garantía, Y Regulaciones

Battery 18V

Technical Data

Battery Data
Article Nr. Name
4211603085 Battery
Battery Charger Data
Battery charger
Battery charger operating
temperature
Other chargers not allowed. Charging the battery on a
not approved charger is considered as altering the sys-
tem and will make the tool certification invalid.
Ambient Temperature
For best battery performance and life time, keep battery
within temperature intervals.
Operating temperature, charge
Operating temperature, discharge
Transportation temperature
Storage temperature
Do not place battery in direct sunlight.
Declarations

EU DECLARATION OF CONFORMITY

We, Atlas Copco Industrial Technique AB, SE-105 23
STOCKHOLM SWEDEN, declare under our sole responsi-
bility that the product (with name, type and serial number,
see front page) is in conformity with the following Direc-
tive(s):
2014/30/EU (EMC)
Harmonized standards applied:
EN 55014-1:2017/A11:2020, EN 55014-2:2015, EN
61000-6-2:2005, EN 62133-2:2017
Authorities can request relevant technical information from:
Product Compliance Manager, Atlas Copco Industrial Tech-
nique AB, SE-105 23 Stockholm Sweden
Stockholm, 1 December 2021
Carl von Schantz, Managing Director
Technical Compatible
Type Data Tools
Li-ion 18V, ETP SRB
2.5Ah, ETP TBP
45Wh ICB-A
ITB-A
ITB-P
Selector 6
Flex charger, 4211608384
+5 to +40 °C
(+41 to +104 °F)
+5 to +40 °C
(+41 to +104 °F)
0 to +40 °C
(+32 to +104 °F)
−20 to +40 °C
(−4 to +104 °F)
+10 to +25 °C
(+50 to +77 °F)
© Atlas Copco Industrial Technique AB - 9834 4357 00
Signature of issuer
Battery Directive
Information concerning Waste of Batteries:
This product and its information meet the re-
quirements of the Battery Directive (2006/66/
EC), and must be handled in compliance with
the directive.
Batteries are marked with a crossed-out wheeled
bin symbol without a single black bar under-
neath. The battery must be recycled either ac-
cording to local regulations or sent to your
"Customer Center" for handling.
UK DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB,
SE-105 23 STOCKHOLM SWEDEN, declare
under our sole responsibility that the product
(with name, type and serial number, see front
page) is in conformity with the following UK
Regulation(s):
S.I. 2016/1091
Designated Standards applied:
EN 55014-1:2017/A11:2020, EN 55014-2:2015,
EN 61000-6-2:2005, EN 62133-2:2017
Authorities can request relevant technical information from:
Product Compliance Manager, Atlas Copco Industrial Tech-
nique AB, SE-105 23 Stockholm Sweden
Stockholm, 1 December 2021
Carl von Schantz, Managing Director
Signature of issuer
Authorised Representative UK:
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead
Hertfordshire HP2 7EA
Safety Information
3