Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Information
Regional Requirements
WARNING
This product can expose you to chemicals including
lead, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For
more information go to
https://www.p65warnings.ca.gov/
Information regarding Article 33 in REACH
The European Regulation (EU) No. 1907/2006 on Registra-
tion, Evaluation, Authorization and restriction of Chemicals
(REACH) defines among other things requirements related to
communication in the supply chain. The information require-
ment applies also to products containing so called Substances
of Very High Concern (the "Candidate List"). On 27 June
2018 lead metal (CAS nr 7439-92-1) was added to the Candi-
date List.
In accordance with the above this is to inform you that cer-
tain electrical components in the product may contain lead
metal. This is in compliance with current substance restric-
tion legislation and based on legit exemptions in the RoHS
Directive (2011/65/EU). Lead metal will not leak or mutate
from the product during normal use and the concentration of
lead metal in the complete product is well below the applica-
ble threshold limit. Please consider local requirements on the
disposal of lead at product end of life.
Conformity to North American Standards
5015332
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
4
Listed
Conforms to Std. UL 62133
Certified to CSA Std C22.2
No. 62133
© Atlas Copco Industrial Technique AB - 9834 4357 00
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the prod-
uct cease to be legible or become detached, replace with-
out delay.
• The product must only be installed, operated and ser-
viced by qualified personnel in an industrial environ-
ment.
Product Specific Instructions
Operation
General Operation Safety
Read these safety instructions before use.
Operation
• Check the battery pack for damage before every use. Do
not use damaged devices.
• The battery voltage must match the voltage mentioned
on the type plate of the charger and tool.
• Use power tools only with specifically designated bat-
tery packs. Use of any other battery packs may create a
risk of injury and fire.
• Do not incinerate, dissemble or crush the battery pack.
• Avoid contact with fluids oozing out of defective battery
packs. Rinse with water in case of accidental contact
with fluid. Consult a doctor if fluid comes into contact
with eyes.
Charging
• Other chargers than the one stated under Battery
Charger Data are not allowed. Charging the battery on
a not approved charger is considered as altering the sys-
tem and will make the tool certification invalid.
• Insert only clean and dry battery packs into the battery
holder of the charger.
• If a protective cover is used on the battery, make sure the
cover is removed and look for potential damage before
charging.
• Check for damage on the battery before charging. Do not
charge any battery pack that has been damaged during
use or by accident (e.g. dents on the housing or any other
damages). Replace damaged battery packs.
• Always remove fully charged batteries from the charger.
Do not let the fully charged battery remain on the
charger.
• Do not operate the charger close to an explosive environ-
ment, for example close to a gas filling station.
• We recommend users to operate the charger in a defined
protected and secure area (e.g. in charging cabinets or
under supervision).
• Make sure the charger is stable when charging, to ensure
that the batteries do not fall to the floor.
If you identify noise or extensive heat from a battery:
1.
If charging, unplug the charger. Do not remove the bat-
tery.
Battery 18V
Publicidad
Tabla de contenido
