Heating System - exide EV640 Manual De Usuario

7.5 Bluetooth issue
● ( Pre-conditions: Battery voltage as measured on the battery terminals should be > 10.6V) Recharge the battery to restore
any low voltage protection that might deactivate the Bluetooth function
● The APP does not connect to the battery
• Make sure Bluetooth is enabled on the mobile phone and that the battery is not too far away
• If problem remains try to delete and re-install the APP
• Remove or turn off any other Bluetooth equipment or other sources of potential interference 2.4 GHz such as Wi-Fi that may
interfere with the signal
• If possible try to connect to another battery or use another mobile phone to install the APP
• In case the problem persists contact Exide dealer

7.6 Heating system

● Pre-condition: Battery temperature below 0 °C and above -20 °C to be below for the heater to start working and the charger
to start charging the battery)
• At temperatures above 0 °C (±3 °C) the battery will accept charge and the heater will not activate
• At temperatures below -20 °C (±3 °C) the battery will be fully disabled and the heater will not activate
• Check that there are no other alarms of BMS protection triggered in the APP
● If the battery does not accept charge when temperature is in the range -20 °C to 0 °C
• Check the battery temperature in the APP to confirm that it is within the range where the heater is active
• Check that the charger is active and can supply charging voltage and current
• In case of not visible charge or temperature increase from the APP contact Exide dealer
5
10