Ruroc ATLAS 4.0 Manual De Instrucciones página 8

BLUETOOTH SYSTEM
(ELECTRONICS)
To install your Bluetooth system, release
the small magnetic hatch at the rear of the
helmet and insert your Atlas in-helmet audio
device. Allow for the device to correctly seat
itself onto the internal connection points,
when this a positive click.
Every ATLAS comes compatible with
Shockwave. To install your Shockwave
correctly please
continuing from
(Bluetooth System).
Visit our 'how to' guides
MIC
AT4_MAN_01-00
follow these steps
the previous page
for more information.
SPEAKER INSTALL
1. To begin, remove the internal ear pads by
gently unfastening the poppers on each
side.
2. Once removed fold the earpads out of
the way keeping the sides closest to the
lower part of the shell connected. Once the
earpads are out of the way you should now
be in view of the speaker Velcro on each
side of the EPS as well as the microphone
Velcro at the front of the helmet.
3. Place the microphone into position at the
front of the helmet in the indicated location
marked. Chase the connecting wire back to
the speaker and secure to the first Velcro
point.
4. Take the trailing wire and connect to the
3.5mm AUX port. Repeat on the left hand
side of the helmet with the single speaker.
SPEAKER
VELCRO
08
AUX