Auto Mode; Mesh Mode; Charging The Battery - Reer NightGuide SmartLight Instrucciones De Uso

Auto mode

In AUTO mode, the light will switch on automatically when it is dark and motion
is detected.
2 - 3m
The sensor has a detection range of 120° and up to 7 metres in front of the sensor and
3 metres to the side of the sensor, as shown in the figure below.
Note: In AUTO mode, the light will only come on when it is dark thanks to the light sensor.
120°
5 - 7 m
GB

MESH mode

Make sure your mobile device is connected to a secure 2.4 GHz network and that Bluetooth is activated.
1. Download and install the Smart Life app from the App Store or Google Play Store.
2. Open the app and select "Create a new account" if you don't have one already, or sign in with your existing account.
3. Press the blue plus symbol in the upper right corner of the app to add the device.
4. The light has been identified and can now be added. Now press "Add" and then the blue plus sign. If the light is not detected automatically, you will need to
reset the night light. You do this by turning the switch to "OFF-MESH-OFF-MESH-OFF-MESH". Then the night light has been reset and should be detected.
5. After successfully adding the night light, press "Finish" and you will be taken to the night light's main menu.

Charging the battery

The blue charge status LED on the night light flashes to indicate that the battery is low. The LED shines blue constantly while the night light is charging. Once the battery
is fully charged, the light goes out. Use a USB power adapter with 5V and minimum 1A to charge the night light.
10