General Safety Instructions; Safety Instructions For Installation; Device Description - Reer NightGuide SmartLight Instrucciones De Uso

General safety instructions

! Check the unit for visible damage before each use. If you detect any damage, do not use the unit.
! Only use the supplied chargers and mains adapters. Make sure that the operating voltage of the power outlet matches that of the mains adapter. Check -
especially when travelling abroad - that the local mains voltage matches the voltage specified on the units and/or mains adapters.
! Except for the battery compartment cover, never open the units or mains adapters, as there is a risk of electric shock. If a unit does not work correctly, please do
NOT try to fix the problem yourself. Please contact your dealer in the case of any problems.
! Avoid bringing the battery and/or electrical connection contacts on the units into contact with metal objects.
! This product is not a toy! Do not allow children to play with the unit.
Safety instructions regarding installation
!
The power lead must be secured out of the reach of children to avoid any risk of strangulation. Do not use extension cables.
! DO NOT place the device in the vicinity of radio transceivers or microwaves. Radiant emissions from these devices can significantly affect radio reception.
! Do not use the units near water or in humid places. Do not submerge the units in water.
!
Do not rinse the units under running water.
! Avoid extreme heat and direct sunlight.
!
The light source of this light cannot be replaced; when the light source has reached the end of its life, the whole light has to be replaced.
! In order to ensure adequate brightness, make sure that the power adapter has an output of DC5V and a minimum of 1A.
! DO NOT install or operate near extreme heat sources, moisture or corrosive substances.
!
Do not use the light if it has a damaged cable or other damage, or after a malfunction has occurred.
! Always place the night light out of your child's reach (minimum distance: 1 metre).
! Never place the night light inside the crib, cot or playpen.

Device description

Front
Illuminated
area
Infra-red
motion
sensor
Charge
status LED
OFF/MESH/AUTO switch:
OFF: switch off
MESH: Bluetooth connection
with a smart device
AUTO: motion sensor
OFF MESH AUTO
Holder for the
fastening strap
Back
Magnet
9
OFF MESH AUTO
INPUT 5V
Micro USB
charging socket
GB