Instruction For Use - flow-med dry-cap uv 1.1 Instrucciones De Uso

EN INSTRUCTION FOR USE
Dry&Clean Mode (120 min)
The Dry&Clean mode is an automatic program and combines fast drying with
an efficient fan with UV-C light at the beginning and end of the drying time
for perfect hygiene.
Using first time
1. Plug the USB cable into a USB socket of the dual-port USB power supply and the USB-C plug into the socket on the back of your dry-cap uv 1.1®. You can
plug the USB cable of the charging station into the second USB socket.
2. Then plug the power supply unit into a mains socket. i The dry-cap uv 1.1® is ready to use
Operation Dry&Clean Mode (120 min)
3. Place the dry-cap uv 1.1® with the acrylic hood over the charging station with the rechargeable hearing aids.
4. Press the left button (Dry&Clean mode) and the care program (drying + UV-C) starts automatically.
• The fast drying by fan is controlled by a microprocessor and runs for 120 min i LED permanent light
• Ultraviolet light (253,7 nm) eliminates germs and bacteria to 99.9% within 2 min i LED blink light
• After 2 min the UV-C light switch off automatically, the drying process continues i LED permanent light
• Within the last 2 min of the 120 min drying program, a second UV-C hygiene runs i LED blink light
• After 120 min the dry-cap uv 1.1® automatically shutdown to stand-by i LED switch off
Drying and hygiene are complete, the charging of the hearing aids in the charging station continues and can remain under the dry-cap uv 1.1®
after the charging station is switched off.
5. Lift the dry-cap uv 1.1® up and off next to the charging station. Remove the dried and hygienically cleansed hearing aids from your charging station.
Clean Mode (2 min)
The Clean Mode is a short-term hygiene program and starts the optimized
UV-C light, which effectively eliminates up to 99.9% of germs, bacteria and
fungi present in the household.
2