Storage; Disposal - HOLZMANN MASCHINEN DSM200DS Instrucciones De Servicio

Use only brushes recommended by your retailer with an indicated speed equal to or greater than
the speed indicated on the nameplate of the tool.
We recommend that you check periodically the condition of your bench grinder, in particular the
condition of the brush and the state of the power supply.
Brush Exchange Procedure:
8. Remount the outer brush flange.
9. Screw the fixing nut back on and tighten it, but without exaggerating!

16.3 Storage

Improper storage can damage and destroy important components. Store packed or
unpacked parts only under the intended environmental conditions.
A special feature of grinding tools is that they can undergo changes during storage due to
unfavourable environmental conditions, which reduce their strength properties, so that safety is
no longer guaranteed.
Therefore, store the machine and its tools only in dry, evenly tempered, frost-free rooms. This
prevents moisture absorption.
Maintaining constant temperatures prevents the formation of stress cracks due to uneven heating
or cooling.
For this very reason, protect the machine and its tools from direct sunlight. Especially with
synthetic resin bonded tools, the ageing process can be accelerated during storage due to
unfavourable ambient conditions.
Grinding tools should be stored on a flat surface, for example on shelves. Care must be taken to
avoid deflection of the grinding wheels and to ensure that the pressure on the lowest layers does
not become too high when the grinding wheels are placed on top of each other. In both cases this
can result in dangerous cracks. Therefore, the base must have sufficient stiffness to prevent
deflection; the stack height must be limited in the case of superimposed grinding wheels. It is
advisable to store the abrasives in a clearly arranged manner according to the type of abrasive
tool so that they can be easily removed without having to be repositioned.

16.4 Disposal

The machine contains recyclable materials. Observe the national waste
disposal regulations. Never dispose of the machine, machine components or
equipment in residual waste. If necessary, contact your local authorities for
information on available disposal options. If you buy a new machine or
equivalent from your dealer, he is obliged in certain countries to dispose of
your old machine properly.
HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
1. Make sure that the power supply is disconnected.
2. Secure the motor shaft by aligning the hole in the motor shaft
to the left of the brush with the hole in the shaft housing (B).
3. Unscrew the brush nut with a flat spanner.
4. The right side nut has a right-hand thread, i.e. it must be
loosened counterclockwise.
5. Remove the outer brush flange.
6. Replace the used brush with a new one (make sure the flanges
and mounting rod are clean before reassembling the brush).
7. Check that the bore of the brush matches the shaft of the
brush holder. Use reducing rings if necessary.
www.holzmann-maschinen.at
NOTE
28
DSM200DS