Multiview - Lindy 38338 Manual De Usuario

User Manual
Rear
8. HDBT: HDBaseT output port. Connect a compatible HDBaseT receiver using a single Cat.6 or above
cable for all data signals. Please do not connect to a network port.
9. HDMI: HDMI output port. Connect to an HDMI display.
10. 3.5mm: LR stereo audio output port. Connect to speakers or headphones to get de-embedded audio.
11. HDMI 1 / HDMI 2 / HDMI 3 / DP / USB-C: Video input ports. Connect to HDMI, DisplayPort and USB
Type C source devices. Please note: Type C source must support DisplayPort Alternate mode.
12. RS-232: Connect to a PC, Serial Controller or Serial device via phoenix block 3-way connection for the
pass-through transmission of RS-232 commands.
13. 24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the transmitter.
Side
UPGRADE: USB Type A port. Connect to a PC for firmware update.
Auto Switch
Push HDMI 3 and DP buttons at the same time to activate Auto Switch mode, a message will pop up as
soon as the function is activated or. It can be managed also via RS-232 commands, please see below.

Multiview

It supports 5 Multiview display modes, users can select them pushing buttons on the front panel or via
RS-232 commands:
SINGLE: Inputs selection
PIP: Inputs selection,
PBP: Inputs selection and display ratio selection
s
ub window size and position selection
English