Uline TORNADO H-10166 Manual De Instrucciones página 5

CLEANING THE DUST TUBE
The vacuum features a dust tube designed to optimize
cleaning power. For best performance, routinely check
and clear excess dust and other debris.
WARNING! To avoid electrical shock or
injury from moving parts, always turn off the
power switch and unplug the power source
plug before performing maintenance or
troubleshooting. Always unplug by grasping
the power source plug. Never pull on the
power cord to unplug.
NOTE: Cover floor with newspaper to catch
any loose material or dust removed during
cleaning.
1. Release bag tension spring. (See Figure 12)
Figure 12
2. Remove filter cover screw, filter cover and filter.
(See Figure 13)
3. Unplug connector plug. (See Figure 14)
Figure 13
PAGE 5 OF 24
MAINTENANCE CONTINUED
Figure 14
4. Lift dust tube (A) while
pressing the tube
release button (B)
located under the
rubber collar. Tube
release button can be
pressed through the
rubber collar (C).
(See Figure 15)
5. Use a wire brush to
clean out the inside of
the dust tube (A) and
the top section of the
base (D). (See Figure 15)
6. Align tube release button on the tube and rubber
collar. Reconnect tube with the base. Ensure that
tube snaps securely in place.
7. Replace connector plug back into base of vacuum.
8. Replace filter and filter cover. Secure with previously
removed screw.
C
A
D
B
Figure 15
1022 IH-10166