Technical Specifications; Cleaning Instructions - Starlyf CORDLESS VAC Manual De Instrucciones

STARLYF CORDLESS VAC
STARLYF CORDLESS VAC
holds the motor (1), filter (2), lithium rechargeable battery (3) and
dustbin (4). These parts can be disassembled to clean the filter
and the dustbin. See the CLEANING INSTRUCTIONS section.
The main unit has a fixed connector opening (5) where the
accessories you plan to use can be attached.
ATTACHING AN ACCESSORY TO THE MAIN UNIT OR THE
ALUMINIUM EXTENSION WAND
- THE STARLYF CORDLESS VAC® and the aluminium
extension wand are designed to attach to the accessories
included in the main set. Use the combination that best suits
your needs Fig. 4.
STARLYF CORDLESS VAC
• To install the battery, insert the tab into the slot of the vacuum
cleaner, as shown in Fig. 3. Reverse these steps in order to re-
move it.
• While the battery is installed in the main unit, insert the charger
plug into the port next to the connection button for the lithium
rechargeable battery and plug the other end into the mains.
• Do not charge the battery for more than 12 hours. Overcharg-
ing can reduce the charge duration. Do not let the battery die
before recharging it.
• The LED pilot light (6) will blink while the device is charging.
As the battery charges, the lights will start turning green. The
light will stay green and will stop blinking when the device is fully
charged.
• The device will be completely charged in 4 to 4½ hours and
will run for approximately 20 minutes, depending on individual
use.
• Unplug the charger from the device and the cable from the
mains.
INSTRUCTIONS FOR USE:
Once the battery has been properly charged, you can start using
the vacuum.
Connect the accessory you plan to use to the vacuum's fixed
connector opening (5) until you hear a click.
The STARLYF CORDLESS VAC
first is strong suction power and is activated by pressing the ON/
OFF button once. The second speed is even stronger suction
power and is activated by pressing the ON/OFF button a second
time. (7)
To stop the unit, press the ON/OFF button a third time. The
sequence is S1-S2-OFF.
DUSTBIN MAXIMUM FILL LEVEL
- Do not let the dirt exceed the level of the dust filter (2), as this
may reduce the suction power Fig. 8.
EMPTYING THE DUSTBIN
- Empty the dustbin when it is full or when you notice a
considerable drop in the product's suction power.
- Press the tab on the base and empty the dustbin into the
rubbish Fig. 5.
CHANGING THE FILTER
- Change the filter when you notice a considerable reduction in
the product's suction power.
- Remove the filter cover (9) and press the PUSH button Fig 6.
- Check the filter status regularly. To take out the filter, remove
the cover by turning the dustbin from left to right. Reverse these
steps to reinstall the filter Fig. 7.

CLEANING INSTRUCTIONS:

ASSEMBLY INSTRUCTIONS:
®
consists of the main unit, which
®
CHARGING INSTRUCTIONS:
®
motor has two speeds. The
®
- Do not clean STARLYF CORDLESS VAC
products such as volatile liquids or solvents. Do not immerse it
in water. Use a damp cloth and a non-abrasive cleaning product
or mild soap. Allow to air dry.
- To clean the dustbin (4), press the tab on the base (10) and
empty the dustbin into the rubbish. Rinse the dustbin and let it
air dry.
- For enhanced maintenance, after each use, remove the fil-
ter cover (9) and press the PUSH button. The filter (2) in the
main unit can be removed by turning the cover. It should then be
washed in water and allowed to air dry.

TECHNICAL SPECIFICATIONS

Adaptor:
• Input power: 100-240 V - 50/60 Hz – 24,0 W
• Output power: 26,0 V
* Appendix1
Device:
• Input power: 22.2 V
• Suction power: 23.9 W
• Power consumption: 140 W
Battery:
· Voltage: 22.2 V
· Material: Li-ion
· 2000 mAh
DISPOSAL OF MATERIALS
A symbol of a crossed-out wheeled bin means you
should find out about and follow local regulations
about disposing of this kind of product.
Do not dispose of this product as you would other household
waste.
Dispose of this device in accordance with the corresponding
local regulations.
Electrical and electronic devices contain hazardous substances
that can have harmful effects on the environment and/or human
health and should be recycled properly.
The battery must be removed before disposing of
the product. To do so, unplug the device from the
mains. Open the battery compartment cover with a
screwdriver and remove the battery. The battery must
be disposed of safely.
HOW TO REMOVE THE BATTERY FROM THE DEVICE
- Warning: it is important for the battery to be completely
discharged before it is removed from the device.
- Warning: the device must be disconnected from the mains
while the battery is being removed.
To remove the battery, see the section STARLYF CORDLESS
VAC CHARGING INSTRUCTIONS
®
The instruction manual is available from http://www.industex.
com
Quality Warranty:
This product is covered by a warranty against manufacturing
defects subject to the time periods stipulated by the legislation in
force in each country.
This warranty does not cover damages resulting from
inadequate use, negligent commercial use, abnormal wear and
tear, accidents or improper handling.
Australia & New Zealand only
This product has the benefit of certain Consumer Guarantees.
These are prescribed by the Australian Consumer Law & the
5
ENGLISH
with chemical
®
500 mA 13,0 W