GE JGP3030 Manual Del Propietário página 10

Cleaning the Cooktop (Cont.)
Burned-On Residue
NOTE: DAMAGE to your glass surface may occur if you
use scrub pads other than those recommended.
1. Allow the cooktop to cool.
2. Spread a few drops of a ceramic cooktop cleaner on
the entire burned residue area.
3. Using a non-scratch cleaning pad for ceramic
cooktops, rub the residue area, applying pressure as
needed.
4. If any residue remains, repeat the steps listed above
as needed.
Heavy, Burned-On Residue
1. Allow the cooktop to cool.
2. Use a single-edge razor blade scraper at approximately
a 45° angle against the glass surface and scrape the
soil. It will be necessary to apply pressure to the razor
scraper in order to remove the residue.
3. After scraping with the razor scraper, spread a few
drops of a ceramic cooktop cleaner on the entire burned
residue area. Use a non-scratch cleaning pad to remove
any remaining residue.
4. For additional protection, after all residue has been
removed, polish the entire surface with a ceramic
cooktop cleaner and a paper towel.
Removal of Surface Burners for Cleaning
Turn all controls OFF. Allow cooktop to cool before removing grates and burner parts. When removing the burner
caps and heads, remember their size and location. Replace them in the same location after cleaning.
Round Burner Cap
(Removable)
Round Burner
10
Round Burner
Head
Electrode
Pin indentations
5. For additional protection, after all residue has been
removed, polish the entire surface with a ceramic
cooktop cleaner and a paper towel.
The ceramic cooktop scraper and all recommended supplies
are available through our Parts Center. See instructions under
"Assistance / Accessories" section.
NOTE: Do not use a dull or nicked blade.
Burner cap
Burner head
Electrode
Locator
pins
Burner
base
Gas on Glass Burner
Use a non-scratch cleaning pad for
ceramic cooktops.
Multi-Ring Burner
Cap
Cap
Burner
Electrode
49-2001091 Rev. 2