MAXSA 40227 Instrucciones De Montaje Y Funcionamiento página 4

Installing the Panel
Use the four wood/sheet metal screws supplied (and the wall hangers if needed)to mount
the solar panel onto a solid surface. You can adjust the angle of the solar cell by gently
rotating the solar cell to a different locking position. Remember to set the panel to face
direct sunlight exposure, optimally facing south.
BEFORE FIRST USE OF YOUR SOLAR SECURITY LIGHT
Charge the batteries with the power switch on the main body of your Solar Flood Light
1.
in the OFF position.
Leave the switch in the OFF position for 3 days with the solar panel placed in direct
2.
light. This will ensure that the batteries in your Solar Flood Light have a full charge
prior to normal operation.
OPERATING YOUR SOLAR SECURITY LIGHT
After the initial 3 day charge of your Solar Security Light, move the switch on the main body
to the ON position. When you do this, the light should activate immediately, regardless of
lighting conditions or motion. This is a test activation to show there is power flowing from
the battery to the light. It should last roughly 30 seconds. After this test activation, the
light will function based on the dial settings mentioned below. Your Solar Security Light is
now ready for use.
The metal part right above the motion sensor can be rotated clockwise and counterclockwise
to show or hide the 3 adjustment dials (TIME / SENS / LUX).
All 3 of these adjustment dials have been preset as follows:
TIME - Set at 30 seconds
SENS - Set at a 10 - 15 foot range (when the surrounding temperature is 75 F).
LUX - Set for your Security Light to activate at dusk when motion is detected.
If the above settings are not suitable for your application, then these may be adjusted using
the steps below.
When ready to use, turn the adjustment dials to face the wall and have the arrow on the
bottom facing the front.
4