Jennair JMC2427LL Manual De Instrucciones página 20

FOR SERVICE TECHNICIAN'S USE ONLY
Component Serviceable Side
Humidity Top
Sensor
Magnetron
Thermistor
Grill Top
Thermostat
Convect Rear
Thermostat
Broil Rear
Element
Procedure
1. Unplug microwave oven or disconnect power.
2. Remove the 3-pin connector from MW Appliance Manager.
3.
Measure resistance across pins 1 and 3 and across pins 2 and 3.
4.
Replace the 3-pin connector from MW Appliance Manager.
5. Reassemble all parts and panels before operating.
6. Plug in microwave oven or reconnect power.
1. Unplug microwave oven or disconnect power.
2. Remove wire leads.
3. Measure resistance.
4.
Replace wire leads.
5.
Reassemble all parts and panels before operating.
6. Plug in microwave oven or reconnect power.
1. Unplug microwave oven or disconnect power.
2. Remove wire leads.
3. Measure resistance.
4. Replace wire leads.
5.
Reassemble all parts and panels before operating.
6.
Plug in microwave oven or reconnect power.
1.
Unplug microwave oven or disconnect power.
2.
Remove wire leads.
3. Measure resistance.
4. Replace wire leads.
5. Reassemble all parts and panels before operating.
6. Plug in microwave oven or reconnect power.
1. Unplug microwave oven or disconnect power.
2.
Remove wire leads.
3.
Measure resistance.
4. Replace wire leads
5. Reassemble all parts and panels before operating.
6. Plug in microwave oven or reconnect power.
Results - Resistance
Normal = 2.8 kΩ
(approximately) at
77°F +/- 10°F
(25°C +/- 10°C)
Abnormal = Infinite
Normal = 10 kΩ
(approximately) at
77°F +/- 10°F
(25°C +/-10°C)
Abnormal = Infinite
Normal = Continuity
Abnormal = Infinite
Normal = Continuity
Abnormal = Infinite
Normal = 9 Ω
Abnormal = Infinite
20
Component Location
E
O
V
B
J