Jump Starting - Deca Fast 380 Manual De Instrucciones

Jump starting

U s e t h e a p p l i a n c e o n l y a s a n
emergency starter to support the
vehicle battery. Do not use it alone
instead of the battery.
„ Avoid the formation of flames or sparks. To
avoid sparks, make sure that the clamps
cannot disengage from the poles of the
battery during charging.
„ Stay away from moving parts such as
fans, transmission belts and pulleys.
„ Stay away from hot parts, such as engine
and cooling system to avoid burns.
„ Do not short circuit the terminals for the
emergency start cable because they are
always under tension.
„ Avoids that the red and black clamps
come into contact. Accidental short
circuits of the terminals caused by an
electrical conductor object for example a
tool, a jewel, etc. could generate enough
heat to cause serious burns, electric arc
or cause incandescent metal splashes.
„ Do not reverse the polarity of the positive
"+" negative and "-" terminals
Sequence of operations
Starter battery must be fully charged
(> 80%).
Carefully follow the starting procedure,
failure to comply may affect the life of
the appliance.
1 Make sure that the vehicle ignition
key is in the OFF position: all services
turned off.
2 Insert the cable with the clamps (B)
into the socket (1).
3 Verify the status of the led in the
smart booster cable:
Led GREEN + Led RED blinking
= starter ready for use.
Led RED ON = The starter
battery is too low: charge the
starter.
950065-00 15/07/22
4
Connect red charging clamp to
positive (+) battery terminal and black
charging clamp (-) to negative battery
terminal.
If the battery is installed on a motor
vehicle, first connect the clamp to the
battery terminal that is not connected
to the bodywork. Afterwards, connect
the second clamp to the bodywork at
a point far from both the battery and
the petrol pipes.
5 Verify the status of the led in the
smart booster cable:
Led GREEN on = you have 30
seconds to start the vehicle.
After 30 seconds without starting,
the two led will return to the
condition of step 3; disconnect
and then reconnect the cable with
the clamps (B)
Led RED on = See paragraph
"Troubleshooting".
6
Rotate the ignition key for up to 3
seconds.
If the vehicle did not start wait at
least 30 seconds before trying again.
If the vehicle did not start even the
second time wait at least 2 minutes.
¾ After starting leave the engine running and
disconnect the starter:
¾ Disconnect in the order the black clamp
"-" and then the red clamp "+".
¾ Disconnect the cable with the clamps from
the starter and put everything into its box.
Use as power supply
1 Insert the cable USB (C,D) into
the USB socket (2,3) or insert the
exit cable (not provided) with the
appropriate adapter into the socket
(5)
2 Press the key(6) to ON.
3 Insert the cable in the device to be
powered.
8