Publicidad
English
1. LIST OF PARTS
2. Insert A‐E31R at the end of part A‐E11R, then connect A‐E11R to A‐E7 and A‐E13.
3. Note: do not tighten the nut now.
4. Note: do not tighten the nut now.
5. Slide the two buttons in the grooves of parts A‐E8L and A‐E8R.
6. Screw the end of A‐E8L to the bolt, turn the bolt to insert in the groove then tighten the nut.
7. Connect and fix A‐E15 to A‐E11R on the triangular part A‐E30 with the bolt and the nut.
8. Slide the bolt in the groove of part A‐E23. Then use another bolt to connect ‐E23 to A‐E29.
9. Screw the end of part A‐E9 to the bolt, turn the bolt to insert in the groove then tighten the nut.
10.
Slide the bolt in the groove of part A‐E9. Then use another bolt to connect A‐E9 to A‐E11R/A‐E11L.
11.
Note: do not tighten the nut now.
12.
Install the plastic part A‐E32 in the direction shown on the picture.
13.
Slide A‐E24 in the groove of the A‐E18.
14.
Adjust A‐E28 in the appropriate position then tighten with the bolt and the nut.
15.
Note: the silicone‐based mastic and the hot‐melt glue applicator are not provided. You must buy
them.
16.
Silicone‐based mastic.
17.
Hot‐melt glue applicator.
18.
Tip: glue parts A‐E9 & A‐E10 carefully. Install the polycarbonate panels in the right place.
19.
Fix part A‐E32 which is located at the bottom of the door, in part A‐E6.
20.
Pass A‐E22 through A‐E32 which is at the other end of the door, and then place it in a central
position.
21.
Use the clip "w" to loop PC with the profile, as indicated.
22.
Rear
23.
Front
24.
Note :
25.
Remove about 2 inches of film from the borders of the panel before installation. Then remove all the
other films after assembly.
26.
The UV-protected side of the panel is covered with a opal white film which must be facing the sun.
27.
The two sides of the PC panel are covered with a thin film- one transparent and an opaque white
side. The UV-protected side of the panel is covered with an opaque white film which must be facing the
sun.
Publicidad
