Publicidad
English
1. Parts list
2. First Insert D-B30R to the below of D-B9,then connct D-B10 and D-B7.
3. Note: Do not tighten the nut now
4. Sliding one bolt to the channel of D-B15 and D-B17 separately, then fix the D-B32 with Base.
5. Aimed the bottom of D-B14 at bolt, rotate bolt in order to inserted into the grooves.
6. Note: do not tighten the nut now.
7. Window.
8. Sliding D-B24 into the track of D-B12
9. Adjust D-B28 into the right place, then tighten with the bolt and nut.
10. Door.
11. Install plastic piece D-B31 in the direction of the image.
12. Insect the polycarbonate panel D-B43 to the D-B4.
13. Note: We not supply the silicone sealant and glue gun, you need buy them on local.
14. Silicone sealant.
15. Glue gun.
16. Only advice: Glue profile D-B13&D-B14 carefully, then install the polycarbonates on the right
place.
17. Profile D-B18 pass through the D-B31 which one on the top of door, then set it to the middle.
18. Fix D-B31 which on the bottom of door on profile D-B6.
19. Use bolt and nut to stop the door.
20. Adjust D-B31 in order to smooth sliding the door.
21. Use the 'W' clip to buckle the PC sheet with the profile like this.Make one end of clip into the
gloove and make it support to the profile, then force the other end make the clip tensional, put the
other end into the groove.
22. Rear
23. Front
24. Note :
25. Remove approximately 2 inches of film from all sheet edges before installing. remove all film
immediately after the constructions completed.
26. The UV-protected side of the sheet is covered with opal white film and must face towards the
sun.
27. Two sides of PC sheet are covered with thin film, one side's film is transparent, another side's
film is opal white.The UV-protected side of the sheet is covered with opal white film and must face
towards the sun.
Publicidad
