Intended Use; Assembly - Batavia MAXXPACK 18 V BT-GS001 Manual De Usuario

1× Carrying strap
1× Manual
1× Safety instructions

5. Intended use

The battery-powered pressure sprayer is
suitable for outdoor use in a well-ventilated
environment. It has been designed for
spraying household and garden chemicals
for private use, such as insecticides,
fungicides, herbicides and fertilisers. The
unit can also be used to water plants. Not
suitable for professional use.
Only liquid fertilisers, herbicides and
pesticides approved by the local authorities
in the country of use are allowed to be used.
Attention: Not suitable for acid-based
herbicides (e.g. acetic acid), peroxides,
acids, alkalis and solvents.

6. Assembly

WARNING: Appropriate protective
equipment, including face, respiratory and
hand protection and proper footwear,
should be worn at all times.
WARNING: Before assembly, switch off the
unit and remove the battery.
Assembling the spray lance and hose
6.1
a. Screw the telescopic spray lance (3) on
the pistol grip (5) (See Fig. B).
b. Assemble the hose (10) onto the pistol
grip and tighten it with the fixing nut
(16) (See Fig. C).
c. Connect the other end of the hose to
the housing and tighten it with the fixing
nut (See Fig. D).
Attention: Fill the tank with water for the
first time and check the hose connections.
Always check for leaks. Repair any leaks
before using the unit.
Attaching the shoulder strap
6.2
a. Hook the ends of the shoulder strap
(15) into the strap attachment (8).
Inserting the battery
6.3
The unit is delivered without battery and
without charger!
a. Open the cover (13) and hold it (See
Fig. E).
b. Slide the battery (14) into the holder
provided. Make sure that the battery
snaps on correctly. Cover closes
automatically and is held shut by
magnets.
Preparing spray product and filling the
6.4
reservoir
• Always prepare the spray product
according to the manufacturer's
instructions. Quantity should be
determined according to the actual
need.
• Spraying agents should have a watery
consistency.
• Never prepare pesticides in living
rooms, sheds or food storage areas, but
only in the open air.
• When using spraying agents prepared
on the basis of plant preparations,
these liquids must be filtered before
pouring them into the reservoir.
a. Switch off the unit and remove the
battery.
b. Put the unit down on an even surface.
c. Unscrew the tank cap/measuring cup
(7) from the tank. Fill the sprayer
reservoir (12) with the required amount
of water.
d. Measure the required amount of
spraying agent into the measuring
cup (7).
e. Pour the liquid into the tank using the
funnel (17).
f. Screw the tank cap (7) back onto the
pressure sprayer, ensuring that it is
firmly screwed on.
g. Replace the battery.
• Spray solutions may be pre-mixed and
then poured into the tank. Use a funnel.
Attention: Be sure to clean the measuring
cap or funnel thoroughly after each use.
When pre-mixing the spray solution, clean
the mixing bottle that was used for this
purpose.
Attention: It is important to clean the unit
thoroughly after each use. Leaving liquid in
an unused unit for a long period of time can
cause the moving parts and joints to stick
together.
English
7