Dunsch DU30040-30CTF Instrucciones Originales página 25

-
Before using, always visually inspect to see that the tools are not worn or
damaged. Replace worn or damaged elements and bolts in sets to preserve
balance.
3) Operation
-
Operate the machine only in daylight or in good artificial light.
-
Please always place the appliance on even and stable surfaces.
-
Do not operate or store the appliance in wet or humid surroundings.
-
Always be sure of your footing on slopes.
-
Walk, never run.
-
Switch on the motor carefully according to instructions and with feet well
away from the blade(s).
-
Do not put hands or feet near or under rotating parts. Keep clear of the
discharge opening at all times.
-
Do not transport the machine while the power source is running.
-
Stop the machine, and remove the battery from the device. Make sure that all
moving parts have come to a complete stop.
• whenever you leave the machine,
• before clearing blockages or unclogging chute,
• before checking, cleaning or working on the machine,
• after striking a foreign object. Inspect the machine for damage and
make repairs before restarting and operating the machine; if the
machine starts to vibrate abnormally (check immediately),
• inspect for damage,
• replace or repair any damaged parts,
• check for and tighten any loose parts.
4) Maintenance and storage
-
Keep all nuts, bolts and screws tight to be sure the machine is in safe working
condition.
-
Be careful during adjustment of the machine to prevent entrapment of the
fingers between moving blades and fixed parts of the machine.
-
Always allow the machine to cool down before storing.
-
Replace worn or damaged parts for safety. Use only genuine replacement
parts and accessories.
-
Never disassembly the guards for cutting attachments.
GB
23