Filter Cleaning; Nozzle Cleaning - Uline H-10168 Manual De Instrucciones

Figure 2
Figure 3
v
• Disconnect from power supply prior to servicing.
Always unplug the power cord from the outlet.
• Clean nozzles periodically to maintain optimal
spray pattern and prevent nozzles from getting
clogged.
• Frequently check and clean filter to maintain
best quality spray.

NOZZLE CLEANING

1. Turn nozzle counterclockwise to remove from mist
ring. Soak nozzle in jar with desired cleaning solution.
2. With nozzle in jar, shake to dislodge any possible
sediment.
3. Soak spray nozzles for 5-10 minutes.
4. Tap front end of nozzles on a hard surface while
holding the threaded end to dislodge any trapped
sediment.
PAGE 2 OF 6
INSTALLATION CONTINUED
2. Push the top spring-loaded clip in, then twist it
3. Turn on water source (hose/faucet) to flush any
4. Connect the adapter hose to the water source.
5. Connect the other end of adapter hose to the
6. Turn on water source while connected to misting ring
7.
8. Turn off water source when finished with use.
MAINTENANCE
5. Rinse nozzle with fresh water and attach to mist ring.
6. Repeat steps 1-5 with any clogged nozzle.

FILTER CLEANING

1.
2. Rinse under fresh water to clean.
1-800-295-5510
uline.com
in between the metal cage and turn sideways.
Release clip to lock into place. Repeat for two
remaining spring-loaded clips to finish securing
the misting ring. (See Figure 2)
possible settled debris for 30 seconds. Turn off
the water source.
misting ring. (See Figure 3)
for one minute to purge the system and remove any
impurities.
Plug fan into a GFI-rated outlet and turn it on.
Unscrew on/off valve to remove filter.
0922 IH-10168