TER ATLANTE EVO Instrucciones De Uso Y Mantenimiento página 4

1 USE AND MAINTENANCE INSTRUCTIONS
(English - Translation of the original instructions)
Conformity to Community Directives: 2014/30/UE, 2014/35/UE, 2006/42/CE
Conformity to CE Standards: EN 60204-1, EN60947-1, EN 60947-5-1, EN 60529, EN 61326-1
Complying with accident prevention regulation BGV C1 (only for Germany)
C
Markings:
ending)
(p
Operational temperature: -25°C +80°C
Protection degree: IP65 / IP67
ATTENTION
Do not use the equipment in environments with a potentially explosive atmosphere or corrosive agents.
Suitable for use in salt mist environments according to the standards (IEC 60068-2-11 and STD UL 50E),
depending on the version. Contact with oils, acids and solvents may damage the equipment.
Operations of installation, use and maintenance must be carried out by skilled personnel only.
Wiring shall be properly done according to the current instructions.
Before installation and maintenance disconnect the equipment from the power mains.
Any change to parts of the equipment will invalidate the rating plate data and identification of the
equipment, and render the warranty null and void.
Should any component need replacement, use original spare parts only.
TER is not liable for damages caused by improper use of the equipment and installation which is not
made correctly.
MAINTENANCE
The conditions of the equipment must be checked monthly.
Check that the fixing points are stable and that the cable is in perfect conditions.
Check that the casing is not damaged or dented.
Do not make holes or notches on the casing, as this may damage the internal card and alter the IP
protection degree.
In case of any mechanical or electronic failure, replace the equipment: DO NOT open the equipment
under any circumstances as this would affect its efficiency.
DO NOT oil and/or grease the shaft and the rotating parts.
Make sure you always follow the directions given in the documentation supplied with the product.
ATTENTION: failure to follow these instructions and technical specifications will jeopardize functioning
and safety of the system.
4